How to apply instructions are given along with the pack,you can also refer to
Or alternative Method
Installation:
Step 1:
Initially make sure that Silhouette Wall Art is properly stuck with transfer paper. Remove
bubbles by using squeegee if any. Furnish decal to remove all bubbles, working
from center to corners to remove big bubbles.
Step 2:
Leaving both coatings on (protective backing and transfer
paper), place the Silhouette Wall Art on wall as per markings. Use masking tape
to position at the desired location. Stand back at some distance to review its
position & change it if needed.
Step 3:
Now your wall art is perfectly placed on wall along with
masking tape. Now start with largest section to peel off the protective backing
paper while making sure that wall decal is lifting off the paper & only
clinging to the transfer paper. If decal is not clinging to transfer paper,
burnish the problem area with squeegee/ Credit Card or by placing your hand
behind problem area as you work your way down.
Make sure that Silhouette Wall Art l & transfer paper
will keep adhered to wall as you go to minimize bubbles.
Step 4:
After paper backing is completely removed, run squeegee over
wall decal & transfer paper from center to edges.
Now you are almost done, slowly peel off transfer paper from
wall leaving behind Silhouette Wall Art
. If you notice Silhouette Wall Art is peeling up along with transfer paper,
reapply it to surface & burnish it with squeegee.
Hope you enjoy the process. :)
