How to apply instructions

How to apply instructions are given along with the pack,you can also refer to

http://www.silhouettedesign.in/how-to-apply.html 

Or alternative Method

Installation:

Step 1:

Initially make sure that Silhouette Wall Art  is properly stuck with transfer paper. Remove bubbles by using squeegee if any. Furnish decal to remove all bubbles, working from center to corners to remove big bubbles.

Step 2:

Leaving both coatings on (protective backing and transfer paper), place the Silhouette Wall Art on wall as per markings. Use masking tape to position at the desired location. Stand back at some distance to review its position & change it if needed.

Step 3:

Now your wall art is perfectly placed on wall along with masking tape. Now start with largest section to peel off the protective backing paper while making sure that wall decal is lifting off the paper & only clinging to the transfer paper. If decal is not clinging to transfer paper, burnish the problem area with squeegee/ Credit Card or by placing your hand behind problem area as you work your way down.

Make sure that Silhouette Wall Art l & transfer paper will keep adhered to wall as you go to minimize bubbles.

Step 4:

After paper backing is completely removed, run squeegee over wall decal & transfer paper from center to edges.

Now you are almost done, slowly peel off transfer paper from wall leaving behind  Silhouette Wall Art . If you notice Silhouette Wall Art is peeling up along with transfer paper, reapply it to surface & burnish it with squeegee.

Hope you enjoy the process. :)